SELF
compute-unit - Local
:We strongly recommned directly using our CLI guide to create the
SELF
compute-units.
Starting with the simplest setup, the Local
device operates without a static IP. Without a static IP, the Compute-Unit will not be accessible when using the DiPhyx Dashboard from other devices.
SELF
-Local
Compute-UnitHere are the steps to create a SELF
-Local
compute-unit:
1- Install DiPhyx CLI.
2- Go through the login process in terminal
diphyx login -e YOUR_EMAIL -p YOUR_DIPHYX_PASSWORD
Please visit login for detailed infromation on the login
process
3- Start the dxflow service:
diphyx dxflow up --create-compute-unit
After initiating the service, access the DiPhyx Dashboard on the same device where the service was started. You will see the newly created compute-unit listed under your compute-unit list. The name of the compute-unit corresponds to your device's name.
The compute-unit will only be available for use when its status changes to READY
. To monitor its status, click on Events
in the Dashboard:
Now that the compute-unit is ready, you can begin a new Project
on this unit.
If you decide to rename the compute-unit, click on Adjust
:
type the new name:
Note: This will not change the name of the device, and only change the compute-unit name
Click Adjust
:
To terminate the compute-unit, use the following command::
diphyx dxflow down --terminate-compute-unit
These steps ensure that even without a static IP, you can effectively manage and utilize local compute resources within DiPhyx's framework, enhancing your computational workflow efficiency.